Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

1. CHECK AUTOMATIC BACK DOOR CLOSE SWITCH INPUT SIGNAL 
   1. Turn ignition switch OFF.
   2. Disconnect automatic back door close switch connector.
   3. Check voltage between automatic back door close switch harness connector and ground.

      (+)		(-)	Voltage (Approx.)
      Automatic back door close switch
      Connector	Terminal
      D560	1	Ground	Battery voltage

      Is the inspection result normal? 

      YES: GO TO  3.

      NO: GO TO 2.

2. CHECK AUTOMATIC BACK DOOR CLOSE SWITCH CIRCUIT 
   1. Disconnect automatic back door control module connector.
   2. Check continuity between automatic back door control module harness connector and automatic back door close switch harness connector.

      Automatic back door control module		Automatic back door close switch		Continuity
      Connector	Terminal	Connector	Terminal
      B55	23	D560	1	Yes

   3. Check continuity between automatic back door control module harness connector and ground.

      Automatic back door control module		Ground	Continuity
      Connector	Terminal
      B55	23		No

      Is the inspection result normal? 

      YES: Replace automatic back door control module. Refer to "REMOVAL AND INSTALLATION ".

      NO: Repair or replace harness.

3. CHECK AUTOMATIC BACK DOOR CLOSE SWITCH GROUND CIRCUIT 

   Check continuity between automatic back door close switch harness connector and ground.

   Automatic back door close switch		Ground	Continuity
   Connector	Terminal
   D560	2		Yes

   Is the inspection result normal? 

   YES: GO TO 4.

   NO: Repair or replace harness.

4. CHECK AUTOMATIC BACK DOOR CLOSE SWITCH 

   Refer to "COMPONENT INSPECTION ".

   Is the inspection result normal? 

   YES: GO TO 5.

   NO: Replace automatic back door close switch. Refer to "REMOVAL AND INSTALLATION ".

5. CHECK INTERMITTENT INCIDENT 

   Refer to "INTERMITTENT INCIDENT ".

   : Inspection End.