Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM - WITH INTELLIGENT CRUISE CONTROL " or "WIRING DIAGRAM - WITHOUT INTELLIGENT CRUISE CONTROL ".

1. CHECK METER CONTROL SWITCH SIGNAL 
   1. Turn ignition switch ON.
   2. Check voltage between the following terminals of the meter control switch harness connector M27.

      Meter control switch			Condition	Voltage (Approx.)
      Connector	Terminals
      	(+)	(-)
      M27	1	2	When illumination control switch (-) is pressed	0 V
      			Other than the above	5 V
      	3		When trip reset switch is pressed	0 V
      			Other than the above	5 V
      	12		When illumination control switch (+) is pressed	0 V
      			Other than the above	5 V

      Is the inspection result normal? 

      YES: Inspection End.

      NO: GO TO 2.

2. CHECK METER CONTROL SWITCH HARNESS 
   1. Turn ignition switch OFF.
   2. Disconnect combination meter harness connector M23 and meter control switch harness connector M27.
   3. Check continuity between combination meter harness connector M23 and meter control switch harness connector M27.

      Combination meter		Meter control switch		Continuity
      Connector	Terminal	Connector	Terminal
      M23	41	M27	3	Yes
      	42		1
      	47		12
      	48		2

   4. Check continuity between combination meter harness connector and ground.

      Combination meter		Ground	Continuity
      Connector	Terminal
      M23	41		No
      	42
      	47
      	48

      Is the inspection result normal? 

      YES: Inspection End.

      NO: Repair or replace harness or connectors.