Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM - WITH INTELLIGENT CRUISE CONTROL " or "WIRING DIAGRAM - WITHOUT INTELLIGENT CRUISE CONTROL ".

1. CHECK STEERING SWITCH CIRCUIT 
   1. Turn ignition switch OFF.
   2. Disconnect combination meter harness connector M24 and spiral cable harness connector M30.
   3. Check continuity between combination meter harness connector M24 and spiral cable harness connector M30.

      Combination meter		Spiral cable		Continuity
      Connector	Terminal	Connector	Terminal
      M24	3	M30	24	Yes
      	4		31
      	24		33

   4. Check continuity between combination meter harness connector M24 and ground.

      Combination meter		Ground	Continuity
      Connector	Terminal
      M24	3		No
      	4
      	24

      Is the inspection results normal? 

      YES: Inspection End.

      NO: Repair or replace harness or connectors.