Diagnosis Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK AWD WARNING LAMP
Turn the ignition switch ON.
Does AWD warning lamp turn ON?
YES: GO TO 2.
NO: Proceed to diagnosis procedure. Refer to "DIAGNOSIS PROCEDURE ".
- CHECK PARKING BRAKE SWITCH SIGNAL
With CONSULT
Check "P BRAKE SW" of CONSULT "DATA MONITOR" for "ALL MODE AWD/4WD".
Monitor Item Condition Status P BRAKE SW When the parking brake pedal is operation. ON When the parking brake pedal is not operation. OFF Is the inspection result normal?
YES: GO TO 3.
NO: Proceed to diagnosis procedure. Refer to "DIAGNOSIS PROCEDURE ".
- CRUISE TEST
Drive the vehicle for a period of time.
Does any symptom occur?
YES: Replace electric controlled coupling for mechanical malfunction (mechanical engagement of clutch is not possible). Refer to "VQ37VHR: EXPLODED VIEW " (VQ37VHR), "VK50VE: EXPLODED VIEW " (VK50VE).
NO: Check each harness connector pin terminal for disconnection.