LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2013 >> FX37 Base, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Transfer Case) >> Removal And Installation >> Rear Oil Seal >> VQ37VHR >> VQ37VHR: Removal and Installation >> Removal

VQ37VHR: Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the rear propeller shaft. Refer to "EXPLODED VIEW ".
  2. Remove self-lock nut of companion flange with a flange wrench (commercial service tool).
  3. Put matching mark (A) on the end of the main shaft. The mark should be in line with the mark (B) on the companion flange.
    CAUTION: For matching mark, use paint. Never damage main shaft.
    Fig 1: Identifying Matching Marks On Main Shaft And Companion Flange
    G05727164Courtesy of NISSAN NORTH AMERICA, INC.
  4. Remove the companion flange with a puller (A) (commercial service tool).
    CAUTION: Never damage the companion flange.
    Fig 2: Removing Companion Flange Using Puller
    G05727165Courtesy of NISSAN NORTH AMERICA, INC.
  5. Remove the rear oil seal with the puller (A) [SST: KV381054S0 (J-34286)].
    CAUTION: Never damage the rear case.
    Fig 3: Removing Rear Oil Seal Using Puller
    G05979333Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals