Component Inspection

WARNING: This page is about a different variant/trim than selected.

CHECK TRANSFER FLUID TEMPERATURE SENSOR

Turn ignition switch OFF.
Disconnect AWD solenoid harness connector.

Check resistance between AWD solenoid connector terminals.

AWD solenoid		Condition	Resistance (Approx.)
Terminal		Condition	Resistance (Approx.)
6	7	20°C (68°F)	2.5 kΩ
6	7	80°C (176°F)	0.3 kΩ

Is inspection result normal?

YES: INSPECTION END

NO: Transfer fluid temperature sensor is malfunctioning. Replace electric controlled coupling. Refer to "VQ37VHR: EXPLODED VIEW " (VQ37VHR), "VK50VE: EXPLODED VIEW " (VK50VE).