LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2013 >> FX37 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Engine Mechanical) >> Unit Removal And Installation >> Engine Assembly >> Removal and Installation >> Removal >> Vehicle Underbody

Vehicle Underbody

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove A/T fluid cooler hoses and power steering oil pump oil cooler hoses.
  2. Disconnect ground cable from exhaust manifold cover (bank 2).
  3. Disconnect heated oxygen sensor 2 harness.
  4. Remove three way catalyst and exhaust front tube. Refer to "EXPLODED VIEW " and "EXPLODED VIEW ".
  5. Remove rear propeller shaft. Refer to "EXPLODED VIEW ".
  6. Disconnect lower joint at power steering gear assembly side, and release lower shaft. Refer to "WITHOUT ELECTRIC MOTOR: EXPLODED VIEW " or "WITH ELECTRIC MOTOR: EXPLODED VIEW ".
  7. Disengage A/T control rod at A/T shift selector side. Then, temporarily secure it on the transmission assembly, so that it does not sag. Refer to "EXPLODED VIEW ".
  8. Preparation for the separation work of transaxle is as per the following:
    • Remove rear plate cover from oil pan (upper). Then remove bolts fixing drive plate to torque converter. Refer to "EXPLODED VIEW ".
    • Remove transmission joint bolts that pierce at oil pan (upper) lower rear side. Refer to "EXPLODED VIEW ".
  9. Remove front stabilizer connecting rod. Refer to "EXPLODED VIEW ".
  10. Remove front wheel sensor for ABS from steering knuckle. Refer to "FRONT WHEEL SENSOR: EXPLODED VIEW ".
  11. Remove brake caliper assembly with piping connected from steering knuckle. Temporarily secure it on the vehicle side with a rope to avoid load on it. Refer to "BRAKE CALIPER ASSEMBLY (4 PISTON TYPE): EXPLODED VIEW ".
  12. Separate upper link from steering knuckle. Refer to "EXPLODED VIEW ".
  13. Separate shock absorber from transverse link. Refer to "EXPLODED VIEW ".