Transfer Fluid: Refilling

WARNING: This page is about a different variant/trim than selected.

Remove filler plug (1) and gasket. Then fill fluid up to mounting hole for the filler plug.
Fluid and viscosity: Refer to "FLUIDS AND LUBRICANTS ".

Fluid capacity: Refer to "GENERAL SPECIFICATIONS ".

Fig 1: Checking Fluid Level From Filler Plug Hole
Courtesy of NISSAN MOTOR CO., U.S.A.

CAUTION: Carefully fill the fluid. (Fill up for approximately 3 minutes.)
Leave the vehicle for 3 minutes, and check the fluid level again.
Set a new gasket onto filler plug, and install it on transfer and tighten to the specified torque. Refer to "EXPLODED VIEW ".
CAUTION: Never reuse gasket.