DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.

PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

Go to 2.
CHECK DTC DETECTION
With CONSULT-III
1. Start the engine.
2. Select "SLCT LVR POSI" and "VHCL/S SE-A/T" in "Data Monitor" in "TRANSMISSION".
3. Drive vehicle and maintain the following conditions for 5 seconds or more.
  SLCT LVR POSI : D
  
  VHCL/S SE-A/T : 5 km/h (3 MPH) or more
4. Perform "Self Diagnostic Results" in "TRANSMISSION".
  Is "P1705" detected?
  
  YES: Go to "DIAGNOSIS PROCEDURE ".
  
  NO: INSPECTION END