Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect malfunctioning door switch connector.
3. Check signal between malfunctioning door switch harness connector and ground using oscilloscope.
   DOOR SWITCH INPUT SIGNAL REFERENCE CHART
   
   

   (+)			(-)	Signal (Reference value)
   Door switch
   Connector		Terminal
   Driver side	B16	2	Ground
   Passenger side	B216	2

   Is the inspection result normal? 

   YES: GO TO  3.

   NO: GO TO 2.

1. Disconnect BCM connector.
2. Check continuity between door switch harness connector and BCM harness connector.
   TERMINALS CONTINUITY REFERENCE CHART
   
   

   Door switch			BCM		Continuity
   Connector		Terminal	Connector	Terminal
   Driver side	B16	2	M123	150	Existed
   Passenger side	B216			124

3. Check continuity between door switch harness connector and ground.
   TERMINALS CONTINUITY REFERENCE CHART
   
   

   Door switch			Ground	Continuity
   Connector		Terminal
   Driver side	B16	2		Not existed
   Passenger side	B216

   Is the inspection result normal? 

   YES: Replace BCM. Refer to "REMOVAL AND INSTALLATION ".

   NO: Repair or replace harness.

Refer to "COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: GO TO 4.

NO: Replace malfunctioning door switch. Refer to "REMOVAL AND INSTALLATION ".

Refer to "INTERMITTENT INCIDENT ".

INSPECTION END