Malfunction Code No. 21, 22, 23 Or 24
- CHECK CONTROL UNIT
- Drive for several minutes. Check all tire pressures with CONSULT-II "DATA MONITOR ITEM".
Are all tire pressures displayed 0 kPa?
YES : GO TO 2.
NO : GO TO 3.
- CHECK REMOTE KEYLESS ENTRY RECEIVER CONNECTOR
- Disconnect remote keyless entry receiver harness connector M98.
- Check terminals for damage or loose connection.
- Reconnect harness connector.
OK or NG
OK : Replace BCM refer to "REMOVAL AND INSTALLATION OF BCM ", then GO TO 3.
NG : Repair or replace remote keyless entry receiver harness connector.
- ID REGISTRATION
- Perform ID registration of all transmitters.
Is there any tire that ID can not be registered to?
YES : Replace transmitter of the tire, then GO TO 5.
NO : GO TO 4.
- VEHICLE DRIVING
- Drive at a speed of 40 km/h (25 MPH) or more for several minutes without stopping.
Check all tire pressures with CONSULT-II "DATA MONITOR ITEM" within 15 minutes after vehicle speed becomes 17 km/h (11 MPH).
Does "DATA MONITOR ITEM" display tire pressure as normal without any warning lamp?
YES : INSPECTION END
NO : GO TO 5.
- Drive at a speed of 40 km/h (25 MPH) or more for several minutes without stopping.
- ID REGISTRATION AND VEHICLE DRIVING
- Perform ID registration of all transmitters.
- Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes. Then check all tire pressures with CONSULT-II "DATA MONITOR ITEM" within 5 minutes.
Does "DATA MONITOR ITEM" display tire pressure as normal without any warning lamp?
YES : INSPECTION END
NO : Go to the inspection applicable to DTC.