LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2006 >> FX35 RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Warning Systems >> Tires, Wheels & Tire Pressure Monitoring System (TPMS) >> Trouble Diagnoses >> Self-Diagnosis >> Low Tire Pressure Warning Lamp Diagnostic Chart

Low Tire Pressure Warning Lamp Diagnostic Chart

LOW TIRE PRESSURE WARNING LAMP DIAGNOSTIC CHART

Diagnosis Item Symptom (Ignition switch ON) Low tire pressure warning lamp Cause Action
Low tire pressure warning lamp Warning lamp comes on immediately and turns off after 1 second
G04076583
All wheel transmitters are "activated" (working). None (system OK)
Warning lamp blinks on for 2 seconds, then turns off for 0.2 seconds-repeats
G04076584
All wheel transmitters are not activated. Activate all wheel transmitters. Refer to , "TRANSMITTER WAKE UP OPERATION ".
Warning lamp blinks 1 time
G04076585
Front LH wheel transmitter is not activated. Activate front LH wheel transmitter. Refer to , "TRANSMITTER WAKE UP OPERATION ".
Warning lamp blinks 2 times
G04076586
Front RH wheel transmitter is not activated. Activate front RH wheel transmitter. Refer to , "TRANSMITTER WAKE UP OPERATION ".
Warning lamp blinks 3 times
G04076587
Rear RH wheel transmitter is not activated. Activate rear RH wheel transmitter. Refer to , "TRANSMITTER WAKE UP OPERATION ".
Warning lamp blinks 4 times
G04076588
Rear LH wheel transmitter is not activated. Activate rear LH wheel transmitter. Refer to , "TRANSMITTER WAKE UP OPERATION ".
Warning lamp comes on and does not turn off
G04076589
The fuse for combination meter from battery is pulled out. Check the fuse for combination meter from battery. Install or replace (if needed).
BCM connector pulled out. Check BCM connector. Reconnect if needed.
Low tire pressure or low tire pressure warning system malfunction.
Turn signal lamp Turn signal lamp does not flash 2 times or horn does not sound after transmitter activation.  
  1. Tool J-45295 (special service tool) battery low.
  2. Ignition OFF during activation.
  3. Tool J-45295 (special service tool) not positioned correctly.
  4. Transmitters already activated.
  1. Install new battery.
  2. Make sure ignition is ON during activation.
  3. Position tool correctly during activation.
  4. None
NOTE: If more than one wheel transmitter is NOT activated, the warning lamp blinking patterns for those wheels will combine. (Example: one blink/OFF/three blinks = Rear LH and Rear RH transmitters are not activated.)