Id Registration With Activation Tool

This procedure must be done after replacement of a transmitter or BCM.

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunction might be detected during self-diagnosis depending on control unit which performs CAN communication.

With the ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to the data link connector, then turn the ignition switch ON.
Select "START (NISSAN BASED VHCL)".
Select "BCM" on "SELECT SYSTEM" screen.
NOTE: If "BCM" is not indicated, go to "CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT ".
Select "AIR PRESSURE MONITOR" on "SELECT WORK ITEM" screen.
Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".
With the activation tool (J-45295) pushed against the front-left transmitter position of the tire air valve, press and hold the button 5 seconds.

Fig 1: Identifying ID Registration With Activation Tool
Courtesy of NISSAN MOTOR CO., U.S.A.

Register the IDs in order from FR LH, FR RH, RR RH or RR LH. When ID registration of each wheel has been completed, a buzzer sounds and turn signal lamp (LH/ RH) blinks.

ACTIVATION TIRE POSITION REFERENCE

Activation tire position		Buzzer	Turn signal lamp	CONSULT-II
1	Front LH	Once	2 times flashing	"YET" "DONE"
2	Front RH	2 times
3	Rear RH	3 times
4	Rear LH	4 times

After completing all ID registrations, press "END" to complete the procedure.
NOTE: Be sure to register the IDs in order from FR LH, FR RH, RR RH, to RR LH, or the self-diagnostic results display will not function properly.