Display Item List
DISPLAY ITEM LIST
| CONSULT-II display | Item | Malfunction is detected when... | Reference |
|---|---|---|---|
| CAN COMM CIRC [U1000] | CAN communication | Malfunction is detected in CAN communication. | Check CAN Communication System |
| SEAT SLIDE [B2112] | Seat slide motor | When any manual and automatic operations are not performed, if any motor operations of seat slide is detected for 0.1 second or more, status is judged "Output error". | CHECK SLIDING MOTOR CIRCUIT CHECK SLIDING SENSOR CIRCUIT |
| SEAT RECLINING [B2113] | Seat reclining motor | When any manual and automatic operations are not performed, if any motor operations of seat reclining is detected for 0.1 second or more, status is judged "Output error". | CHECK RECLINING MOTOR CIRCUIT CHECK RECLINING SENSOR CIRCUIT |
| SEAT LIFTER FR [B2114] | Seat lifting FR motor | When any manual and automatic operations are not performed, if any motor operations of seat lifting FR is detected for 0.1 second or more, status is judged "Output error". | CHECK FRONT LIFTER MOTOR CIRCUIT CHECK REAR LIFTER MOTOR CIRCUIT |
| SEAT LIFTER RR [B2115] | Seat lifting RR motor | When any manual and automatic operations are not performed, if any motor operations of seat lifting RR is detected for 0.1 second or more, status is judged "Output error". | CHECK REAR LIFTER MOTOR CIRCUIT CHECK REAR LIFTING SENSOR CIRCUIT |
| TILT OUTPUT [B2116] | Tilt motor | When any manual and automatic operations are not performed, if any motor operations of seat tilt is detected for 0.1 second or more, status is judged "Output error". | CHECK TILT MOTOR CIRCUIT CHECK TILT SENSOR CIRCUIT |
| TILT SENSOR [B2118] | Tilt sensor | When tilt sensor detects 0.1V or lower, or 4.9V or higher, for 0.5 seconds or more. | CHECK TILT SENSOR CIRCUIT |
| TELESCO SENSOR [B2119] | Telescopic sensor | When telescopic sensor detects 0.1V or lower, or 4.9V or higher, for 0.5 seconds or more. | CHECK TELESCOPIC SENSOR CIRCUIT |
| P RANGE SW [B2125] | P RANGE SW | With the A/T selector lever in P position (P range switch ON), if the vehicle speed of 7 km/h (4 MPH) or higher was input the detente switch input system is judged malfunctioning. | CHECK DETENTION SWITCH (P RANGE SWITCH) CIRCUIT |
| UART COMM [B2128] | UART communication | Malfunction is detected in UART communication. | CHECK UART COMMUNICATION LINE CIRCUIT |
NOTE:
- The displays of CAN communication and P range switch display error detecting condition from memory erase to the present on "TIME".
- If error is detected in the past and present error is detected"CRNT" is displayed.
- If error is detected in the past and present error is not detected"PAST" is displayed.
- If error has never been detected, nothing is displayed on "TIME".
- Any items other than CAN communication and P range switch count error detection frequency occurred after erase history to "1-127".
- If error was detected in the past, error detection frequency from memory erase to the present is displayed on "TIME".
- If error has never been detected, nothing is displayed on "TIME".
- Can clear the detected memory.
Normal: Clear memory in normal condition, history is erased and nothing is displayed on "TIME".
Error: Clear memory in error condition, error is detected again and "1" is displayed on "TIME".