LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Santa Fe Calligraphy, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Double Clutch Transmission System Diagnosis - 2.5T (2 Of 4) (Except HEV)) >> DTC P097B-15: Shift Solenoid 'B' Control >> Component Inspection >> S/W Management

S/W Management

WARNING: This page is about a different car, the 2022 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
Inspection Condition Inspection Procedure Reference
  1. Start-up "ON".
  2. Shift lever P.
  3. Vehicle speed 0 km/h.
  4. Battery normal. (above 10V)
  5. NO DTC.
  1. Connect GDS to "Data Link Connector (DLC)".
  2. Select the "Vehicle S/W Management" about related DTC with GDS.
  3. Select "TCU Neutralization" in S/W Management.
  4. After the final work, go to "Verification of Vehicle Repair" procedure.
 Fig.1 to 5
CAUTION: Perform the following procedure for TCU, clutch pack replacement, TCU update, faulty TCU learning.

Fig.1 to 5) TCU Neutralization S/W Management Steps.

G14540720Courtesy of HYUNDAI MOTOR AMERICA
G14540721Courtesy of HYUNDAI MOTOR AMERICA
G14540722Courtesy of HYUNDAI MOTOR AMERICA
G14540723Courtesy of HYUNDAI MOTOR AMERICA
G14540724Courtesy of HYUNDAI MOTOR AMERICA
Inspection Condition Inspection Procedure Reference
  1. Start-up "ON".
  2. Shift lever P.
  3. Vehicle speed 0 km/h.
  4. Battery normal. (above 10V)
  5. NO DTC.
  1. Connect GDS to "Data Link Connector (DLC)".
  2. Select the "Vehicle S/W Management" about related DTC with GDS.
  3. Select diagnostic Air bleeding in S/W Management.
  4. After the final work, go to "Verification of Vehicle Repair" procedure.
 Fig.1 to 4

Fig.1 to 4) Air bleeding S/W Management Steps.

G14540725Courtesy of HYUNDAI MOTOR AMERICA
G14540726Courtesy of HYUNDAI MOTOR AMERICA
G14540727Courtesy of HYUNDAI MOTOR AMERICA
G14540728Courtesy of HYUNDAI MOTOR AMERICA
Inspection Condition Inspection Procedure Reference
  1. Start-up "ON".
  2. Shift lever P.
  3. Vehicle speed 0 km/h.
  4. Battery normal. (above 10V)
  5. NO DTC.
  1. Perform the diagnostic air bleeding function of S/W Management if necessary.
  2. Connect GDS to "Data Link Connector (DLC)".
  3. Select the "Vehicle S/W Management" about related DTC with GDS.
  4. Select air bleeding in S/W Management.
  5. After the final work, go to "Verification of Vehicle Repair" procedure.
 Fig.1 to 4

Fig.1 to 4) Air bleeding S/W Management Steps.

G14540729Courtesy of HYUNDAI MOTOR AMERICA
G14540730Courtesy of HYUNDAI MOTOR AMERICA
G14540731Courtesy of HYUNDAI MOTOR AMERICA
G14540732Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals