LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Santa Fe Calligraphy, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Double Clutch Transmission System Diagnosis - 2.5T (2 Of 4) (Except HEV)) >> DTC P07D8-07: Unable To Engage Gear 8 >> Component Inspection >> S/W Management

S/W Management

WARNING: This page is about a different car, the 2022 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
Inspection Condition Inspection Procedure Reference
  1. Start-up "ON".
  2. Shift lever P.
  3. Vehicle speed 0 km/h.
  4. Battery normal. (above 10V)
  5. NO DTC.
  1. Connect GDS to "Data Link Connector (DLC)".
  2. Select the "Vehicle S/W Management" about related DTC with GDS.
  3. Select "TCU Neutralization" in S/W Management.
  4. After the final work, go to "Verification of Vehicle Repair" procedure.
 Fig.1 to 5
CAUTION: Perform the following procedure for TCU, clutch pack replacement, TCU update, faulty TCU learning.

Fig.1 to 5) TCU Neutralization S/W Management Steps.

G14540565Courtesy of HYUNDAI MOTOR AMERICA
G14540566Courtesy of HYUNDAI MOTOR AMERICA
G14540567Courtesy of HYUNDAI MOTOR AMERICA
G14540568Courtesy of HYUNDAI MOTOR AMERICA
G14540569Courtesy of HYUNDAI MOTOR AMERICA
Inspection Condition Inspection Procedure Reference
  1. Start-up "ON".
  2. Shift lever P.
  3. Vehicle speed 0 km/h.
  4. Battery normal. (above 10V)
  5. NO DTC
  1. Connect GDS to "Data Link Connector (DLC)".
  2. Select the "Vehicle S/W Management" about related DTC with GDS.
  3. Select diagnostic Air bleeding in S/W Management.
  4. After the final work, go to "Verification of Vehicle Repair" procedure.
 Fig.1 to 4

Fig.1 to 4) Air bleeding S/W Management Steps.

G14540570Courtesy of HYUNDAI MOTOR AMERICA
G14540571Courtesy of HYUNDAI MOTOR AMERICA
G14540572Courtesy of HYUNDAI MOTOR AMERICA
G14540573Courtesy of HYUNDAI MOTOR AMERICA
Inspection Condition Inspection Procedure Reference
  1. Start-up "ON".
  2. Shift lever P.
  3. Vehicle speed 0 km/h.
  4. Battery normal. (above 10V)
  5. NO DTC.
  1. Perform the diagnostic air bleeding function of S/W Management if necessary.
  2. Connect GDS to "Data Link Connector (DLC)".
  3. Select the "Vehicle S/W Management" about related DTC with GDS.
  4. Select air bleeding in S/W Management.
  5. After the final work, go to "Verification of Vehicle Repair" procedure.
 Fig.1 to 4

Fig.1 to 4) Air bleeding S/W Management Steps.

G14540574Courtesy of HYUNDAI MOTOR AMERICA
G14540575Courtesy of HYUNDAI MOTOR AMERICA
G14540576Courtesy of HYUNDAI MOTOR AMERICA
G14540577Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals