LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Santa Fe Calligraphy, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Double Clutch Transmission System Diagnosis - 2.5T (2 Of 4) (Except HEV)) >> DTC P074F-73: Unable To Engage (Shift) Gear 7 >> Component Inspection >> S/W Management

S/W Management

WARNING: This page is about a different car, the 2022 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
Inspection Condition Inspection Procedure Reference
  1. Start-up "ON".
  2. Shift lever P.
  3. Vehicle speed 0 km/h.
  4. Battery normal. (above 10V)
  5. NO DTC.
  1. Connect GDS to "Data Link Connector (DLC)".
  2. Select the "Vehicle S/W Management" about related DTC with GDS.
  3. Select "TCU Neutralization" in S/W Management.
  4. After the final work, go to "Verification of Vehicle Repair" procedure.
 Fig.1 to 5
CAUTION: Perform the following procedure for TCU, clutch pack replacement, TCU update, faulty TCU learning.

Fig.1 to 5) TCU Neutralization S/W Management Steps.

G14540535Courtesy of HYUNDAI MOTOR AMERICA
G14540536Courtesy of HYUNDAI MOTOR AMERICA
G14540537Courtesy of HYUNDAI MOTOR AMERICA
G14540538Courtesy of HYUNDAI MOTOR AMERICA
G14540539Courtesy of HYUNDAI MOTOR AMERICA
Inspection Condition Inspection Procedure Reference
  1. Start-up "ON".
  2. Shift lever P.
  3. Vehicle speed 0 km/h.
  4. Battery normal. (above 10V)
  5. NO DTC.
  1. Connect GDS to "Data Link Connector (DLC)".
  2. Select the "Vehicle S/W Management" about related DTC with GDS.
  3. Select diagnostic Air bleeding in S/W Management.
  4. After the final work, go to "Verification of Vehicle Repair" procedure.
 Fig.1 to 4

Fig.1 to 4) Air bleeding S/W Management Steps.

G14540540Courtesy of HYUNDAI MOTOR AMERICA
G14540541Courtesy of HYUNDAI MOTOR AMERICA
G14540542Courtesy of HYUNDAI MOTOR AMERICA
G14540543Courtesy of HYUNDAI MOTOR AMERICA
Inspection Condition Inspection Procedure Reference
  1. Start-up "ON".
  2. Shift lever P.
  3. Vehicle speed 0 km/h.
  4. Battery normal. (above 10V)
  5. NO DTC.
  1. Perform the diagnostic air bleeding function of S/W Management if necessary.
  2. Connect GDS to "Data Link Connector (DLC)".
  3. Select the "Vehicle S/W Management" about related DTC with GDS.
  4. Select air bleeding in S/W Management.
  5. After the final work, go to "Verification of Vehicle Repair" procedure.
 Fig.1 to 4

Fig.1 to 4) Air bleeding S/W Management Steps.

G14540544Courtesy of HYUNDAI MOTOR AMERICA
G14540545Courtesy of HYUNDAI MOTOR AMERICA
G14540546Courtesy of HYUNDAI MOTOR AMERICA
G14540547Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals