DTC Information And Inspection: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
Case 1 |
- Rationality signal monitor - high side
|
- Poor connector connection
- Air cleaner pollution
- Faulty intake system leakage
- Faulty MAPS
|
| Case 2 |
- Rationality signal monitor - low side
|
| Enable Condition |
- Pressure quotient difference between manifold/ambient pressure is less than 0.8
- Time after start for more than 0.5s
- Battery voltage between 11 and 16V
- Signal change is more than 12°/s
- Failure not detected for DTCs
|
| Threshold Value |
Case 1 |
- Filtered reduced area controller is higher than -60 to -40% and lower than 40 to 60% (versus ambient pressure, throttle position)
|
| Case 2 |
- Filtered reduced area controller is higher than -30 to -20% and lower than 20 to 30% (versus ambient pressure value)
|
| Diagnostic Time |
|
| MIL ON Condition |
|