LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 96 (Abs/ESC Diagnosis (2 Of 2)) >> DTC C1643-08: CAN Time-Out Yaw Rate & G Sensor >> Wiring Inspection >> Circuit Inspection

Circuit Inspection

WARNING: This page is about a different car, the 2021 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.
G13484635Courtesy of KIA MOTORS AMERICA, INC.
G13484636Courtesy of KIA MOTORS AMERICA, INC.
Module Circuit Inspection
Inspection Condition (+) Probe (-) Probe Specification
Connector Terminal Connector Terminal
  1. Ignition "OFF".
  2. Disconnect the electrical connector(s) from the concerned component.
SRSCM connector 19 (Memory power) Chassis ground - B+
SRSCM connector 1 (ground) Chassis ground - Approx. below 1Ω
  1. Disconnect the electrical connector(s) from the concerned component.
  2. Ignition "ON".
SRSCM connector 1 (ON/START Input) Chassis ground - B+
CAN communication circuit Inspection
Inspection Condition (+) Probe (-) Probe Specification
Connector Terminal Connector Terminal
  1. Ignition "ON".
HECU connector (W/O EPB) 4 (C-CAN high) Chassis ground - Fig.1
HECU connector (W/O EPB) 5 (C-CAN low) Chassis ground -
HECU connector (With EPB) 19 (C-CAN high) Chassis ground - Fig.1
HECU connector (With EPB) 20 (C-CAN low) Chassis ground -
  1. Ignition "OFF".
  2. Disconnect the electrical connector(s) from the concerned component.
HECU connector (W/O EPB) 4 (C-CAN high) SRSCM connector 26 (C-CAN high) Approx. below 1Ω
HECU connector (With EPB) 19 (C-CAN high)
HECU connector (W/O EPB) 5 (C-CAN low) SRSCM connector 27 (C-CAN low) Approx. below 1Ω
HECU connector (With EPB) 20 (C-CAN low)
  1. Ignition "OFF".
  2. Disconnect the electrical connector(s) from the concerned component.
SRSCM connector 26 (C-CAN high) Chassis ground - ∞ (infinity)Ω
SRSCM connector 27 (C-CAN low) Chassis ground - ∞ (infinity)Ω
  1. Ignition "OFF".
  2. Disconnect the battery (-) terminal.
  3. Disconnect the electrical connector(s) from the concerned component.
HECU connector (W/O EPB) 4 (C-CAN high) HECU connector (W/O EPB) 5 (C-CAN low) Approx. 60Ω
HECU connector (With EPB) 19 (C-CAN high) HECU connector (With EPB) 20 (C-CAN low) Approx. 60Ω
G13484637Courtesy of KIA MOTORS AMERICA, INC.

Good 

No Good