Power Circuit Inspection
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
| Check Item | Specifications | Check Condition | Terminal (+) | Terminal (+) |
|---|---|---|---|---|
| Voltage | Battery Voltage | Ignition SW "ON" | Heater Power Terminal of Sensor Harness | Chassis GND |
- Is voltage display near the specified value?
YES
- Go to "CONTROL CIRCUIT INSPECTION " procedure.
NO
- Check for open or short in the power supply circuit between the main relay and the HO2S. Especially check for "15A Sensor 2 fuse" is installed and not blown. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NOTE:
HO2S must have a clean air reference to function properly. The air is obtained by way of the sensor wire (s). Do not attempt to repair the wire (s), connector, or the terminals.