Control Circuit Inspection
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
| Check Item | Specifications | Check Condition | Terminal (+) | Terminal (+) |
|---|---|---|---|---|
| Voltage | 2~3V | Ignition SW "ON" | "Heater Control Terminal of Sensor Harness" | Chassis GND |
- Is voltage within the specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NOTE: HO2S must have a clean air reference to function properly. The air is obtained by way of the sensor wire (s). Do Not attempt to repair the wire (s), connector, or the terminals.