LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 136 (Air Conditioning System Diagnosis) >> DTC B1281-11: Humidity Sensor Short (Low) - Auto Defog >> DTC Information And Inspection >> Monitor GDS Data

Monitor GDS Data

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect GDS to Data Link Connector (DLC).
  2. Turn the ignition switch ON and warm up the vehicle up to an operational temperature.
  3. Select "Auto Defog Humidity Sensor" parameter on the "Current Data" of the GDS.
    G12595886Courtesy of HYUNDAI MOTOR AMERICA
  4. Does the value remain the same?

    YES 

    • Go to next procedure.

    NO 

    • Fault is intermittent caused by poor contact of the component's or control module's connector. Thoroughly check connectors for looseness, poor connection, bending, corrosion, deterioration, or damage.
    • Repair or replace relevant component (s) as necessary and then go to "VERIFICATION OF VEHICLE REPAIR ".