Monitor GDS Data

WARNING: This page is about a different variant/trim than selected.

With vehicle raised on a lift, start the engine and place transaxle in Drive. Let vehicle idle and verify speedometer indicates approx. 10 km/h or more (6 mph or more) on the instrument cluster.
Connect GDS and select ABS/ESP system.
Monitor the "WHEEL SPD SENSOR-FR" parameter on the "Current Data" list.
Specification: 10 km/h or more (6 mph or more)
Is value within the specification?
YES
- Wheel speed sensor is OK. Go to "SIGNAL CIRCUIT INSPECTION [WITH ABS] " procedure
NO
- Check for open or short circuit between wheel speed sensor (FR) and ABS/ESP control module
- If problems are found, repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure
- If OK, Check wheel speed sensor (FR) as follow:
  - Gap between wheel speed sensor and trigger wheel (Air gap: 0.3~1.1 mm (0.011 ~ 0.043 in))
  - Trigger wheel condition
- Replace wheel speed sensor as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.