ETC Output 1 Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
■ Check for Short to Ground in ETC Output 1 Circuit
- IG "OFF".
- Disconnect ETC Connector.
- Measure resistance between ETC Output 1 terminal of ETC harness connector and chassis ground.
Specification: Infinite
- Is resistance within specification?
YES
- Go to next procedure.
NO
- Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
■ Check for Short to Power in ETC Output 1 Circuit
- IG "OFF".
- Disconnect ETC Connector.
- IG "ON".
- Measure voltage between ETC Output 1 terminal of ETC harness connector and chassis ground.
Specification: Approx. 0 V
- Is voltage within specification?
YES
- Go to next procedure.
NO
- Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
■ Check for Open in ETC Output 1 Circuit
- IG "OFF".
- Disconnect ETC harness connector and PCM harness connector.
- Measure resistance between both ends of ETC Output 1 line.
Specification: Below 1 Ω.
- Is resistance within specification?
YES
- Go to next procedure.
NO
- Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.