Power Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
- IG "OFF".
- Disconnect Ignition Coil connector.
- IG "ON" & ENG "OFF".
- Measure the voltage between Ignition Coil power terminal of Ignition Coil harness connector and chassis ground.
Specification: Approx. 12 V
The image file (SVG, SWF, GIF) doesn't exist./data/Passenger/HY/HMA/ENG/ETM-Images/HY-LF33-IMAGES-ENG/
- Is the measured voltage within specification?
YES
- Go to "SIGNAL CIRCUIT INSPECTION " procedure.
NO
- Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.