Ground Circuit Inspection

WARNING: This page is about a different variant/trim than selected.

■ Check Short to power

IG "OFF".
Disconnect Ignition Coil connector.
IG "ON" & ENG "OFF".
Measure the voltage between Ignition Coil ground terminal of Ignition Coil harness connector and chassis ground.
Specification: Approx. 0 V

The image file (SVG, SWF, GIF) doesn't exist./data/Passenger/HY/HMA/ENG/ETM-Images/HY-LF33-IMAGES-ENG/
Is the measured voltage within specification?
YES
- Go to "Check Open" procedure below.
NO
- Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.

■ Check Open

IG "OFF".
Disconnect Ignition Coil connector.
Measure the resistance between Ignition Coil ground terminal of Ignition Coil harness connector and chassis ground.
Specification: Below 1Ω

The image file (SVG, SWF, GIF) doesn't exist./data/Passenger/HY/HMA/ENG/ETM-Images/HY-LF33-IMAGES-ENG/
Is the measured resistance within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.