LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Luxury, Automatic >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Hood Primary Latch Release Cable Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Hood Latch Cable Grommet
    GM1372823Courtesy of GENERAL MOTORS CORP.
  1. Attach the mechanic's wire to the exterior end of the cable.
  2. Using the mechanic's wire as an aid, guide the cable underneath the sound insulation and pass the exterior portion of the cable through the cowl panel.
  3. Seat the cable grommet (1) to the cowl panel (2).
    4. Fig 2: Identifying Hood Release Handle
    GM1553863Courtesy of GENERAL MOTORS CORP.
  4. Install the release handle (3) to the knee bolster.
    5. NOTE: Refer to Fastener Notice .
  5. Install the screws (1) that retain the release handle to the knee bolster.

    Tighten:  Tighten the bolts to 2 N.m (18 lb in).

    6. Fig 3: View Of Hood Latch Cable
    GM1372561Courtesy of GENERAL MOTORS CORP.
  6. Route the cable as previously noted.
  7. Attach the cable to the retainers on the inner fender.
  8. Install the cable to the hood latch assembly.
  9. Install the hood latch. Refer to Hood Primary and Secondary Latch Replacement .
  10. Install the grille. Refer to Grille Replacement .
scientia non olet · About LEMON Manuals