LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Adventure, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> On-Vehicle Repair Instructions >> Range Selector Lever Cable Replacement (3.7L) >> Removal Procedure

Removal Procedure

  1. Ensure the vehicle is in the park position.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. Fig 1: Range Selector Cable & Components
    GM1302081Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not pull on the boot portion of the cable.
  3. Complete the following in order to disconnect the range selector cable (3) from the transmission range selector lever ball stud.
    1. Insert a flat-bladed tool between the range selector cable end (5) and the range selector lever (1).
    2. Pry the range selector cable end (5) away from the range selector lever (1).
  4. Remove the retainer (4) from the range selector cable (3).
  5. Push the range selector cable locking tabs inward toward each other to release from the bracket (2).
  6. Lower the vehicle.
  7. Remove the cowl side trim panel. Refer to Cowl Side Trim Panel Replacement .
  8. Pull the driver side carpet up, enough to access the range selector cable.
    9. Fig 2: Identifying Cable & Floor Panel Grommet
    GM1563042Courtesy of GENERAL MOTORS CORP.
  9. Pull the cable grommet (2) up through the floor panel.
  10. Make note of the cable routing under the heat duct (3).
    11. Fig 3: View Of Transmission Range Selector Lever, Shift Control Assembly & Range Selector Cable
    GM1563036Courtesy of GENERAL MOTORS CORP.
  11. Use a flat-bladed tool to separate the range selector cable (2) from the transmission range selector lever ball stud (1).
  12. Release the cable retainer (4) from the shift control assembly (5).
  13. Remove the range selector cable (3) from the vehicle.
scientia non olet · About LEMON Manuals