LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating, Ventilation, And Air Conditioning >> Repair Instructions >> Blower Motor Replacement >> Removal Procedure

Removal Procedure

  1. If equipped, remove the I/P insulator panel. Refer to Instrument Panel Insulator Panel Replacement .
  2. Remove the blower motor insulating cover screws.
  3. Disconnect the electrical connector from the blower motor.
  4. Remove the blower motor insulating cover.
    5. Fig 1: Disengaging Blower Motor (Delphi)
    GM382501Courtesy of GENERAL MOTORS CORP.
  5. Pull the retaining tab down while turning the blower motor counterclockwise in order to disengage the blower motor from the heater/ventilation module.
    6. Fig 2: View Of Blower Motor (Delphi)
    GM382496Courtesy of GENERAL MOTORS CORP.
  6. Remove the blower motor.
scientia non olet · About LEMON Manuals