LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating, Ventilation, And Air Conditioning >> Repair Instructions >> Blower Motor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Blower Motor (Delphi)
    GM382496Courtesy of GENERAL MOTORS CORP.
  1. Install the blower motor.
    2. Fig 2: Turning Blower Assembly Clockwise (Delphi)
    GM382498Courtesy of GENERAL MOTORS CORP.
  2. Install the blower motor to the heater/ventilation module. Turn the blower assembly clockwise until the retaining tab locks into place.
  3. Install the blower motor insulating cover.
  4. Connect the electrical connector to the blower motor.
    5. NOTE: Refer to Fastener Notice .
  5. Install the blower motor insulating cover screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

  6. If equipped, install the I/P insulator panel. Refer to Instrument Panel Insulator Panel Replacement .
scientia non olet · About LEMON Manuals