LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 97 (Door Lock Systems & Door Handles) >> Repair Instructions >> Rear Door Lock Replacement

Rear Door Lock Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Side Door Lock & Components
GM1673114Courtesy of GENERAL MOTORS CORP.
Rear Door Lock Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement (Suburban/Yukon XL/Escalade ESV) or Rear Side Door Trim Panel Replacement (Tahoe/Yukon/Escalade) .
  2. Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement .
1 Inside Door Handle Cable Retainer Clip
2 Rear Side Door Lock Screws (Qty: 3)
NOTE: Refer to Fastener Notice .

Tighten:  10 N.m (89 lb in)


Tip: 
  1. Release the outside door handle rod from the door lock clip.
  2. The mandatory sequence is 3, 1, 2.
3 Rear Side Door Lock
Tip: 
  1. Disconnect the electrical plug.
  2. Transfer all parts to the new lock.