Rear Side Door Window Regulator Replacement (Power)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Side Door Window Regulator & Bolts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Refer to SIR Caution . Preliminary Procedures Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling . Position the rear door window approximately half way down in the door. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (Suburban/Yukon XL/Escalade ESV) or Rear Side Door Trim Panel Replacement (Tahoe/Yukon/Escalade) . Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
1	Rear Side Door Window Regulator Bolts (Qty: 5) NOTE: Refer to Fastener Notice . Tighten: 9 N.m (80 lb in) Tip: Tape the window to the door frame to prevent it from moving. Loosen the 2 bolts that attach the window to the window regulator.
2	Rear Side Door Window Regulator Tip: Disconnect the electrical connector. Transfer the power window motor to the new regulator. Refer to Rear Side Door Window Regulator Motor Replacement (Power) .

Callout

Component Name

CAUTION: Refer to SIR Caution .

Preliminary Procedures

Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
Position the rear door window approximately half way down in the door.
Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (Suburban/Yukon XL/Escalade ESV) or Rear Side Door Trim Panel Replacement (Tahoe/Yukon/Escalade) .
Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .

Rear Side Door Window Regulator Bolts (Qty: 5)

NOTE: Refer to Fastener Notice .

Tighten: 9 N.m (80 lb in)

Tip:

Tape the window to the door frame to prevent it from moving.
Loosen the 2 bolts that attach the window to the window regulator.

Rear Side Door Window Regulator
Tip:

Disconnect the electrical connector.
Transfer the power window motor to the new regulator. Refer to Rear Side Door Window Regulator Motor Replacement (Power) .