LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Steering Wheel & Steering Column) >> Repair Instructions >> Shift Lever Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shift lever to the steering column.
  2. Connect the shift lever electrical connector.
    3. Fig 1: Locating Shift Lever & Screw
    GM1700835Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the TORX® head shift lever screw.

    Tighten:  Tighten the screw to 20 N.m (15 lb ft).

  4. Roll the seal over the TORX® head shift lever screw.
  5. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
scientia non olet · About LEMON Manuals