LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (HVAC System - Manual) >> Repair Instructions >> Mode Actuator Replacement

Mode Actuator Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Mode Actuator & Screws
GM1696344Courtesy of GENERAL MOTORS CORP.
Mode Actuator Replacement

Callout Component Name

Preliminary Procedure

  1. Remove the knee bolster. Refer to Knee Bolster Replacement (Cadillac) or Knee Bolster Replacement (Except Cadillac) .
  2. Remove the air outlet duct - floor LH. Refer to Floor Air Outlet Duct Replacement - Left Side .
  3. Disconnect the electrical connector from the mode actuator.
1 Screw, Mode Actuator (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:  1.6 N.m (14 lb in)

2 Actuator, Mode
Tip:  Mode actuator cam is now accessible.