LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Condenser Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Tie Bar To Radiator Brace & Bolts
    GM401547Courtesy of GENERAL MOTORS CORP.
  1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
  2. Remove upper tie bar. Refer to Tie Bar Replacement - Upper .
    3. Fig 2: View Of Discharge Hose At Condenser
    GM363062Courtesy of GENERAL MOTORS CORP.
  3. Remove the compressor discharge hose assembly bolt from the condenser.
  4. Disconnect the compressor discharge hose assembly from the condenser.
    5. Fig 3: Evaporator Tube To Condenser
    GM363033Courtesy of GENERAL MOTORS CORP.
  5. Remove the evaporator tube nut from the condenser.
  6. Disconnect the evaporator tube from the condenser.
  7. Remove the insulator retainer bolts and the upper insulator retainers.
  8. Remove the condenser from the vehicle.
scientia non olet · About LEMON Manuals