LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Compressor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: A/C Belt Tensioner
    GM370869Courtesy of GENERAL MOTORS CORP.
  1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
  2. Install a ratchet into the air conditioning (A/C) belt tensioner adapter opening.
  3. Rotate the A/C belt tensioner clockwise in order to relieve the tension on the belt.
  4. Remove the A/C belt from the A/C compressor.
  5. Slowly release the tension on the A/C belt tensioner.
  6. Remove the right front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  7. Remove the wheel house panel from the vehicle. Refer to Front Wheelhouse Liner Replacement .
  8. Remove the discharge hose bolt from the A/C compressor.
  9. Remove the discharge hose from the A/C compressor.
  10. Remove the suction hose bolt from the A/C compressor.
  11. Remove the suction hose from the A/C compressor.
  12. Discard the sealing washers. Cap all of the openings.
  13. Disconnect the electrical connections.
    14. Fig 2: View of A/C Compressor & Bolts
    GM648141Courtesy of GENERAL MOTORS CORP.
  14. Remove the A/C compressor mounting bolts. The lower right bolt (3) will stay with the compressor due to a lack of clearance.
  15. Remove the A/C compressor (2) from the bracket (1).
  16. If replacing the A/C compressor. Refer to Compressor Oil Balancing .
scientia non olet · About LEMON Manuals