LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Parking Brake System) >> Repair Instructions >> Park Brake Pedal Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Park Brake Cable Grommet
    GM376010Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure the grommet for the front park brake cable is properly seated in the front floor panel.
  1. Insert the front brake cable through the hole in the front floor panel and seat the pass-through grommet.
  2. Position the floor carpet to the floor pan.
    3. Fig 2: View Of Park Brake Lever Mounting Nuts
    GM1688777Courtesy of GENERAL MOTORS CORP.
  3. Position the park brake pedal assembly on the side panel.
    4. NOTE: Refer to Fastener Notice .
  4. Install and finger tighten the mounting nuts.

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

  5. Connect the park brake warning lamp connection.
    6. Fig 3: View Of Park Brake Release Lever Handle & Bolt
    GM376009Courtesy of GENERAL MOTORS CORP.
  6. Install the park brake release handle to the instrument panel.
  7. Install the park brake release handle bolt.

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

  8. Install the hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement .
  9. Install the left side instrument panel electrical center/junction block. Refer to Instrument Panel Electrical Center or Junction Block Replacement - Left Side .
  10. Raise the vehicle.
    11. Fig 4: View Of Park Brake Cable - Front/Intermediate
    GM363830Courtesy of GENERAL MOTORS CORP.
  11. Install the front park brake cable to the frame and press the retainer into place.
  12. Connect the front park brake cable to the front to intermediate park brake cable connector.
  13. Lower the vehicle.
  14. Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
  15. Adjust the park brake. Refer to Park Brake Adjustment .
scientia non olet · About LEMON Manuals