Rear Bumper Fascia Replacement (All Utility, Cadillac ESV)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Bumper Fascia Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the rear wheelhouse inner panel extensions. Refer to Wheelhouse Liner Panel Replacement - Rear .
1	Rear Fascia Bolts (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 9 N.m (80 lb in)
2	Rear Fascia Plastic Bolts (Qty: 4) Tip: Disconnect the rear object detection sensor harness located in the right end of the fascia and any other electrical connectors before attempting removal. Tighten: 9 N.m (80 lb in)
3	Rear Fascia Bolts (Qty: 4) Tighten: 9 N.m (80 lb in)
4	Rear Fascia Plastic Retainers (Qty: 2)
5	Fascia Assembly Tip: If replacing the Z-71 fascia then new fender flare holes will need to be drilled as needed.