LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rear Door Replacement

Rear Door Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Rear Side Door & Components
GM1688580Courtesy of GENERAL MOTORS CORP.
Rear Door Replacement

Callout Component Name
CAUTION: Refer to SIR Caution .

Preliminary Procedures

  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  2. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (Suburban/Yukon XL/Escalade ESV) or Rear Side Door Trim Panel Replacement (Tahoe/Yukon/Escalade) .
1 Rear Side Door Upper Hinge Bolts (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:  25 N.m (18 lb ft)


Tip:  Support the door before removing the hinge nuts.
2 Rear Side Door Lower Hinge Bolts (Qty: 2)

Tighten:  25 N.m (18 lb ft)

3 Rear Side Door
Tip:  If replacing the door transfer door components as needed.