LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Panel Replacement - Cargo Box Bridge Side Outer

Panel Replacement - Cargo Box Bridge Side Outer

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Cargo Box Bridge Side Outer Panel Assembly
GM1711726Courtesy of GENERAL MOTORS CORP.
Panel Replacement - Cargo Box Bridge Side Outer

Callout Component Name

Preliminary Procedures

  1. Remove rear compartment cover assembly. Refer to Cargo Box Front Cover, Center Cover, and Rear Cover Replacement .
  2. Remove cargo box bridge center panel. Refer to Panel Replacement - Cargo Box Bridge Center (Avalanche)  or Panel Replacement - Cargo Box Bridge Center (Escalade EXT) .
  3. Remove cargo box bridge side inner panel. Refer to Panel Replacement - Cargo Box Bridge Side Inner (Avalanche)  or Panel Replacement - Cargo Box Bridge Side Inner (Escalade EXT) .
1 Cargo Box Bridge Side Outer Panel Assembly
Tip:  Pull up on panel in order to release fasteners.
scientia non olet · About LEMON Manuals