LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Lid Replacement - Cargo Box Stowage Box >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Cargo Stowage Box & Bolts
    GM1708946Courtesy of GENERAL MOTORS CORP.
  1. Position the cargo box stowage lid (3) to the vehicle.
    2. IMPORTANT: Ensure that the feather edge is properly sealed to the glass and side panels.
  2. Install the cargo box water run channel.
    3. Fig 2: View Of Cargo Stowage Box & Bolts
    GM1708946Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the bolts to the cargo box stowage lid (1).

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

  4. Install the bolt inside the cargo box stowage lid assembly (2).

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

  5. Install the cargo box bridge side inner panel. Refer to Panel Replacement - Cargo Box Bridge Side Inner (Avalanche)  or Panel Replacement - Cargo Box Bridge Side Inner (Escalade EXT) .
  6. Install the assist handle. Refer to Assist Handle Replacement - Endgate (Avalanche) .
  7. Install the cargo box cover assembly. Refer to Cargo Box Front Cover, Center Cover, and Rear Cover Replacement .
  8. Close the endgate.
scientia non olet · About LEMON Manuals