Wiper Motor Replacement - Rear
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS CORP. Wiper Motor Replacement - Rear
| Callout |
Component Name |
|
Preliminary Procedures
- Remove the liftgate interior trim panel. Refer to Liftgate Trim Panel Replacement
.
- Remove the rear wiper arm assembly. Refer to Wiper Arm Blade Replacement - Rear .
- Remove the rear wiper motor pivot shaft nut and spacer.
Tighten:
Tighten the rear wiper motor pivot shaft nut to 4.9 N.m (43 lb in) after the motor and spacer have been installed.
|
| 1 |
Rear Window Wiper Motor Assembly Bolts (Qty: 2) Tighten:
9 N.m (80 lb in)
|
| 2 |
Rear Window Wiper Motor Assembly
Tip:
- Pull the wiper motor forward towards the front of the vehicle.
- Disconnect the electrical connector.
- Remove the rear wiper motor from the inner liftgate panel.
- Check the rear wiper shaft spacer upon installation of the new wiper motor to ensure proper position of the spacer to the rear liftgate panel.
|