LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Wiper System & Washer System) >> Repair Instructions >> Air Inlet Grille Panel Replacement

Air Inlet Grille Panel Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Air Inlet Panel & Components
GM1673096Courtesy of GENERAL MOTORS CORP.
Air Inlet Grille Panel Replacement

Callout Component Name

Preliminary Procedure

  1. Remove the fixed antenna, if equipped. Refer to Fixed Antenna Replacement (Avalanche/Escalade EXT) .
  2. Remove the windshield wiper arms. Refer to Wiper Arm Replacement .
  3. Remove the rear hood seal. Refer to Hood Rear Seal Replacement .
1 Air Inlet Panel End Panel
2 Air Inlet Panel Retainer (Qty: 2)
3 Air Inlet Panel Screw (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:  9 N.m (80 lb in)
4 Air Inlet Panel Clip
5 Air Inlet Panel
scientia non olet · About LEMON Manuals