Fixed Antenna Replacement (Avalanche/Escalade EXT)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Radio Antenna Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the instrument panel upper trim pad. Refer to Instrument Panel Upper Trim Panel with Windshield Defroster Nozzle Grille Replacement (Cadillac) or Instrument Panel Upper Trim Panel with Windshield Defroster Nozzle Grille Replacement (Except Cadillac) .
1	Radio Antenna Mast NOTE: Refer to Fastener Notice . Tighten: 6 N.m (53 lb in)
2	Air Inlet Grille Outer Cover
3	Radio Antenna Assembly Screw (Qty: 3) Tighten: 5 N.m (44 lb in)
4	Radio Antenna Assembly Tip: Disconnect the antenna cable from the extension cable, from inside of the vehicle. Remove the cable grommet from the body. Tie a long wire to the antenna cable to aid in installation of new antenna. From outside of the vehicle, pull the antenna base and cable assembly until the wire can be easily accessible, ensuring part of the wire is still in the vehicle for installation purposes.