LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Wiper System & Washer System) >> Diagnostic Information and Procedures >> Wiper Always On - Rear

Wiper Always On - Rear

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Wiper Always On - Rear

Step Action Yes No
Schematic Reference: Wiper/Washer Schematics 
Connector End View Reference:  Wiper/Washer Connector End Views  
DEFINITION: Rear wiper is always ON.
1 Did you review the Rear Wiper/Washer System Description and Operation and perform the necessary inspections? Go to Step 2  Go to Symptoms - Wiper/Washer Systems 
2
  1. Turn the ignition ON.
  2. Turn the rear wiper/washer switch to the OFF position.
Is the rear wiper always on?
Go to Step 3  Go to Testing for Intermittent Conditions and Poor Connections
3
  1. Turn the ignition OFF.
  2. Disconnect the rear wiper/washer switch.
  3. Turn the ignition ON.
Is the rear wiper always on?
Go to Step 4  Go to Step 6 
4
  1. Turn the ignition OFF.
  2. Disconnect the window wiper module-rear.
  3. Turn the ignition ON.
Test the rear wiper switch signal circuit for a short to voltage. Refer to Circuit Testing and to Wiring Repairs .Did you find and correct the condition?
Go to Step 10  Go to Step 5 
5 Test the rear window washer switch signal circuit for a short to voltage. Refer to Circuit Testing and to Wiring Repairs .
Did you find and correct the condition?
Go to Step 10  Go to Step 8 
6 Inspect for poor connections at the rear wiper/washer switch. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs .
Did you find and correct the condition?
Go to Step 10  Go to Step 7 
7 Replace the rear wiper/washer switch. Refer to Wiper/Washer Switch Replacement - Rear .
Is the repair complete?
Go to Step 10  -
8 Inspect for poor connections at the window wiper module-rear. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs .
Did you find and correct the condition?
Go to Step 10  Go to Step 9 
9 Replace the window wiper module-rear. Refer to Wiper Motor Replacement - Rear .
Is the repair complete?
Go to Step 10  -
10 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3