Liftgate Center Applique Replacement (Tahoe, Yukon)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Liftgate Center Applique Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Open the liftgate. Remove the liftgate interior trim panel. Refer to Liftgate Trim Panel Replacement . Remove the 4 applique nuts from inside the liftgate panel. Release the 2 integral retainers from the exterior side of the applique.
1	Liftgate Center Applique Assembly Nuts (Qty: 4) NOTE: Refer to Fastener Notice . Tighten: 6 N.m (53 lb in)
2	Liftgate Center Applique Harness Grommet Tip: Ensure the grommet is secure to the liftgate panel hole prior to the installation of the applique.
3	Liftgate Center Applique Assembly Tip: Pull the applique rearward in order to release the 2 outer integral clips.