Front Fog Lamp Replacement (Tahoe, Avalanche)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Fog Lamp Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove either the LF or RF wheelhouse liner. Refer to Front Wheelhouse Liner Replacement . From the inside of the front bumper fascia, using a blunt instrument, pinch the retainers and push outward on the 2 upper mounting studs for the fog lamp. Using the same blunt instrument, pinch the retainers and push outward on the lower adjustment screw for the fog lamp.
1	Forward Lamp Harness Electrical Connector Tip: Disconnect the electrical connector from the fog lamp socket.
2	Fog Lamp Upper Retention Studs (Qty: 2) Tip: Ensure the retainers are repositioned into the front bumper fascia mounting holes prior to the installation of the new fog lamp.
3	Fog Lamp Adjuster Screw Tip: Adjust/aim the front fog lamps after the new fog lamps have been installed. Refer to Fog Lamp Aiming (Tahoe/Yukon) .
4	Fog Lamp Assembly Tip: Remove the bulb from the lamp assembly and transfer as necessary.