Headlamps Inoperative - Flash to Pass
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Headlamps Inoperative - Flash to Pass
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Headlights/Daytime Running Lights (DRL) Schematics Connector End View Reference: Lighting Systems Connector End Views or Data Communication Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
| 3 |
|
Go to Step 6 | Go to Step 4 |
| 4 | Test the headlamp switch flash to pass signal circuit for high resistance or an open. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 9 | Go to Step 5 |
| 5 | Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 9 | Go to Step 7 |
| 6 | Inspect for poor connections at the harness connector of the dimmer switch. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 9 | Go to Step 8 |
| 7 | Replace the BCM. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 9 | - |
| 8 | Replace the headlamp dimmer switch. Refer to Turn Signal Multifunction Switch Replacement
. Did you complete the repair? |
Go to Step 9 | - |
| 9 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |