Conditions for Clearing the MIL/DTC
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- This DTC will clear on current status after the condition for setting the fault is corrected.
- A history DTC will clear after 100 consecutive ignition cycles without a fault present.
- History and current DTCs can be cleared using a scan tool.
DTC B3802
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Exterior Lights Schematics Connector End View Reference: Lighting Systems Connector End Views or Data Communication Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
| 3 | Test the park lamp switch ON signal circuit for an open or high resistance. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct a condition? |
Go to Step 10 | Go to Step 4 |
| 4 | Test the headlamp switch headlamps ON signal circuit for a short to ground. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct a condition? |
Go to Step 10 | Go to Step 5 |
| 5 |
|
Go to Step 6 | Go to Step 7 |
| 6 | Inspect for poor connections at the harness connector of the BCM. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 10 | Go to Step 8 |
| 7 | Inspect for poor connections at the harness connector of the headlamp switch. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 10 | Go to Step 9 |
| 8 | Replace the BCM. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 10 | - |
| 9 | Replace the headlamp switch. Refer to Headlamp Switch Replacement . Did you complete the replacement? |
Go to Step 10 | - |
| 10 |
|
Go to Step 2 | System OK |