Test Description
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
The numbers below refer to the step numbers on the diagnostic table.
- 3: This step test determines if the problem exists in the wiring or the BCM.
- 4: This step test determines if the problem exists in the wiring or the BCM.
- 5: After replacement of the BCM you must calibrate the new module for proper operation.
DTC B2615
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Interior Lights Schematics Connector End View Reference: Lighting Systems Connector End Views or Data Communication Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 | Inspect the TBC 2B fuse in the instrument panel fuse block. Is the fuse open? |
Go to Step 3 | Go to Step 4 |
| 3 | Test the following circuits for a short to ground. Refer to Circuit Testing
and Wiring Repairs
:
Did you find and correct the condition? |
Go to Step 6 | Go to Step 5 |
| 4 | Test the courtesy lamp supply voltage circuit for the following conditions:
Did you find and correct the condition? |
Go to Step 6 | Go to Step 5 |
| 5 | Replace the BCM. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 6 | - |
| 6 |
|
Go to Step 2 | System OK |